@Xrave Thank you. Found it and that did it. Right next door(tab).
mgw310 tar1090 and graphs1090 is off
I recently received my mgw310. on the status page of the mgw310, the tar1090 and graphs1090 status is off. You click on it and nothing happens. Will this change? I noticed that this seemed a standard feature in the wingbits setup. Why was it disabled? Was it oversight?
1
Reply
Share
Troubleshooting
Wingbits16•posted •active
Geodnet
Rovr
DIMO
If I recall correctly, on the settings page where you can turn on/off the LEDs and stuff, there is also a setting that enables/disables performance graphs. Going off of memory here…