@Martin I hear you. I have mine set up and it kills me each day that its not doing anything and I could be making money. I hope down the line they compensate us through all these inconvenience.
@Martin I hear you. I have mine set up and it kills me each day that its not doing anything and I could be making money. I hope down the line they compensate us through all these inconvenience.
Certain devices have issues with rain. I have gone through 1 bad one that was repaired and broke again. Will let you know when the replacement gets installed and how it does in the rain.
@illmadness+74c176a3 I hope that was not the issue for me. It has been windy and rainy for the past couple of days before my equipment went under
@illmadness+74c176a3 Mine has been through the worst rainstorm that I has seen in North Georgia in 5 years. The pole even tilted a bit from the wind. So far I have not had any issues.
No issues with my WB200, I've placed it at the highest point possible was top 5% now I'm at top 10% 😎 sometimes it shows rewards status underperforming sometimes healthy.
Overall dandy 👍
no issues with my WB200, only thing I noticed was were I placed my device it’s not the best spot as far as obstructions so im currently not getting the wingbits like I should. I plan on moving it as soon as I get the spare time just gotta fine the right location on my property
@cryptoskater55 yes that can be a challenge especially when you want to connect your ethernet and your power cable
My MGW310 had the LNA issue develop after about 2 weeks. Working with Hyfix to replace it, but it’s a very slow process…
@Xrave My WB200 for a whole month I was able to get 90 wingbits as soon as August 1 came everything went down to 7 wingbit. My Input Messages/s carried from 1- 4 and it would fluctuate. Even though my GPS Satellites was 37.
@Xrave many problems began after a month. Once I began earning within the month the whole system went down on August 1. I used WB200.
@Randevue Mine has been fine and earning between 110 to 135 wings per day. I had an issue when i first onboarded it last month but that was because i had it connected to a network switch and for some reason it wasn't able to update the client version and firmware. As soon as i connected it straight to my router it was fine. What is your location like? How high is your antenna? Something doesn't sound right.
@Xrave listened to your comments on the most recent Moken call w @JD re: geodnet. I'm trying to search here in the forum under your profile where that thread would be because you explained a lot of information about them moving to Solana and I just want to make sure that I understand everything and what I need to do. Thx
@AFriendOfSatan My antena is about 30 ft with clear sky. Im about 5 miles away from the nearest airport. I get about 30 satellite but the problem is I get only 3 to 4 input messages. I use to get enough messages where I would recieve 90 wingbit a day now its only 7. I took picture of the chart and chatgpt told me everything looked good except my Input Messages. My set up never changed.
@Randevue Something is definitely not right. Connect to it's WiFi or local IP address and check the Tar1090 charts. Make sure the client version and firmware are up to date. Firmware should be v2.0.38 and client version 4c6d1b44. Try rebooting it. I have an upgraded 5.5dbi antenna with LMR 400 cable. If it's on Wifi try using ethernet instead. Make sure the antenna is on tight it's possible that water and moisture could get in to where the antenna is attached. I put electrical tape on the connection. I would reach out to support too and see what they say.
@Mediatech Here is the link, but it’s way out of date now after the last AMA. I need to make a new one.
https://moken.io/forum/264/geodnet-gip-7-conept-proposal-upcoming-geodnet-changes?commentId=1905
@Randevue My station was getting about 200 wings per day and then it dropped to about 30 per day
@Randevue possible LNA issue with antenna amplifier. In the tar1090 and graphs 1090 you should see a sudden dropoff. There was a manufacturing issue with those parts hyfix is aware of. contact wingbits support using ai help bubble on winbits page
@avoidbit definitely sounds the the LNA issue. Start the support chat on Wingbits website and ask for a human.
Has anyone experienced their wingbit rod that connects on the top, going loose in the past month effecting their earnings?
Man I wished HyFix took designing these devices seriously, the whole LNA board frying is a joke and it’s 100% on them